Protective Cases for Automotive and Workshop Use

What IP rating do tool trolleys need?

In wash bays and test areas IP65 is required (dust-tight + jet protection). Outdoor workshop carts need IP67. All our cases are IP67 sealed as standard, including pressure equalization valve.

Do your cases support high stacking loads?

Standard: 5 cases stacked (approx. 300 kg total height). Reinforced base plates and corner reinforcements in PA66+GF30 raise the stack load to 8 cases / approx. 500 kg. Tested per EN 12195-1.

Are the cases resistant to oil and coolant?

PP resists mineral oil, grease and most coolants (ASTM D543). Against aggressive solvents (acetone, toluene) we recommend PC or PC+ABS. We provide the plastic material data sheet on request.

How are cases designed for paint lines?

Antistatic (surface resistance 10⁶-10⁹ Ω) so no static discharge transfers to painted parts. Material PP or PEI (Ultem). EVA foam floor resistant to solvents like isopropanol and thinner for 72 h. Two drain holes for rinse liquid.

Do you maintain production traceability?

Yes. Each production batch receives a batch number appearing on the delivery note, label and inspection report. Traceability from raw material batch through injection molding parameters to final inspection per ISO 9001:2015. Inspection reports are available as PDF on request.

Do the cases fit existing workshop trolleys and shelving systems?

Yes. Our 8-series uses standard Euro edge dimensions so the cases fit standard workshop trolleys to DIN EN 15620. For different grid dimensions we manufacture to your drawing. Standard external sizes range from 230 x 170 x 90 mm to 620 x 430 x 300 mm; custom sizes are possible from 500 pieces.